Ford F-650 Super Duty prices

On the affected vehicles, the engine oil fill cap may be marked with ‘5W-20’ instead of the correct ‘5W-30’ marking. As a result, confusion may result regarding the correct engine oil.

Some 2024 F-Super Duty/F-150 vehicles may exhibit a concern where the vehicle's center display screen gets stuck in a reboot loop of the Ford logo and eventually goes black. This may be due to a concern with the software on the telematics control unit module (TCU). To correct the condition, follow the Service Procedure to reprogram the TCU and then perform a battery disconnect to make sure the accessory protocol interface module (APIM) receives the correct date from TCU.

Some 2023-2024 F-Super Duty vehicles built on or before 22-Jul-2024 and equipped with a 6.7L engine may exhibit an illuminated malfunction indicator lamp (MIL) with diagnostic trouble codes (DTC) P203B, P206B, and/or P2201:92 stored in the powertrain control module (PCM). This may be due to the software in the PCM. To correct the condition, follow the Service Procedure to reprogram the PCM using the latest software level of the Ford Diagnosis and Repair System (FDRS) scan tool.

This article supersedes TSB 23-2376 to update the Part List and the Service Procedure. Some 2022-2024 F-550 and F-600 F-Super Duty vehicles equipped with a 10R140 automatic transmission and 6.7L diesel engine may exhibit an illuminated powertrain malfunction (wrench) indicator with diagnostic trouble codes (DTCs) P2704 and P0771 stored in the transmission control module (TCM) with poor shift quality and over 5,000 miles (8,000 km) in service. This may be due to wear between the input shaft and the E clutch hub causing the input shaft O-rings to become damaged resulting in an open E clutch circuit. To correct this condition, follow the Service Procedure to replace the E clutch hub and input shaft O-rings.

When replacing the E clutch hub (7P211) on 2020-2024 F-Super Duty and 2024-2025 F-650/F-750 vehicles equipped with a 10R140 transmission, a new washer (7482) has been added and must be installed with the new updated E clutch hub. Refer to the Workshop Manual (WSM), Section 307-01B for proper installation of the washer. Refer to the parts catalog for the appropriate part numbers for the E clutch hub and the washer.