Infiniti QX50 prices

TELEMATICS SERVICE INFORMATION See ITB19-029 for models built after those listed above for a different Service Procedure. SERVICE INFORMATION The Applied Vehicles are equipped with a wireless communication device called a Telematics Communication Unit (TCU). With an active Infiniti Connection® or Infiniti InTouch Services™, the TCU communicates with the Infiniti Data Center to provide various security and convenience services. This bulletin contains important service procedures that must be performed properly in order to set-up and maintain the telematics system for the Applied Vehicles. Ø A table has been provided on the next page that lists the model and year specific steps required to successfully configure a TCU after it has been replaced. Ø A check OFF sheet has been provided on page 21 to print and check off steps as they are performed. Please staple the completed Check OFF Sheet to the repair order.

IF YOU CONFIRM The client states that either the rear hatch is inoperative, or the rear hatch closes after opening only a small amount, AND DTC B2426-23 for “SPINDLE SENSOR LH” and/or DTC B2427-23 for “SPINDLE SENSOR RH” is stored, AND/OR There is a growling type noise from the rear hatch area when opening/closing the rear hatch. · DTC B2426-23 for “SPINDLE SENSOR LH” and/or DTC B2427-23 for “SPINDLE SENSOR RH” may also be stored. HINT: If any DTC other than B2426-23 and/or B2427-23 is stored, this bulletin does not apply. ACTION Replace ONLY the spindle unit that is confirmed to be setting one of the DTCs listed above and/or causing the growling noise. Do NOT replace both spindle units when diagnosis leads to replacement of only one. HINT: Rear hatch spindle units are not hydraulic systems. If a rear hatch spindle unit appears to be leaking, this is normal drainage of water (rain, car wash, condensation) and design intended water management. Do not replace spindle units for suspected

AEB WARNING LIGHT IS ON WITH WARNING MESSAGES DISPLAYED ON COMBINATION METER APPLIED VEHICLES: 2015-2024 Q50 (V37) 2015-2018 Q50 Hybrid (HV37) 2017-2022 Q60 (CV37) 2015-2019 Q70 (Y51) 2015-2018 Q70 Hybrid (HY51) 2019-2024 QX50 (J55) 2022-2024 QX55 (FJ55) 2015-2021 QX60 (L50) 2022-2024 QX60 (L51) 2015-2019 QX60 Hybrid (L50H) 2015-2024 QX80 (Z62) SERVICE INFORMATION The AEB system is designed to turn itself OFF during driving conditions (e.g., rain, snow, fog, etc.) that obstruct its sensors. This behavior is normal, and no repairs should be performed. When the AEB system performs an intentional shutdown, the customer may state the following:  The ICC stopped working while driving,  The AEB/FEB warning light is ON, or turned ON, while driving (Figure 1),  The message “Unavailable Front Radar Obstruction” or “Forward Driving Aids Temporarily Disabled Front Sensor Blocked See Owner's Manual” has displayed while driving (Figure 2). AND  DTC C1A16, C1A16-97, C2582, or C2582-97 is the ONL

***** Retailer Announcement ***** INFINITI is conducting a quality action on specific 2025 QX50 and QX55 vehicles in connection with an on-going investigation. Retailers will inspect both passenger (right) side tires and, if necessary, replace each tire that has a cut inner sidewall. Due to a manufacturing concern, which since has been corrected, the tires may have been damaged during vehicle assembly. ***** What Retailers Should Do ***** PLEASE FOLLOW THE ATTACHED REPAIR INSTRUCTIONS: 1. Verify if vehicles are affected by this quality action using Service Comm or DBS National Service History – Open Campaign I.D. PD133 • New vehicles in retailer inventory can also be identified by using DBS (Sales-> Vehicle Inventory, and filter by Open Campaign).  Refer to IPSB 15-286 for additional information • Some vehicles may still be in transit. Please continue to check newly arriving inventory for QA applicability. 2. Use the attached procedure to remedy any vehicles affected by this quality a

SERVICE INFORMATION In the APPLIED VEHICLES, there are a variety of Seat Belt Warning Lights and Chimes. Refer to the information in this bulletin, along with the related vehicle owner’s manual. Figure 1 Infiniti Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO NOT assume that it does. See your Infiniti retailer to determine if this applies to your vehicle. Seat Belt Warning Light for driver and front passenger.