Mercedes-Benz AMG E 53 prices

Issue A software update will be performed that provides enhancements to the robustness and system stability of the communication module. The update is free of charge and runs in the background, which takes about 8 minutes to install. During this time, the vehicle can be driven without any restrictions, and the new software will be active with the next ignition cycle. Remedy MBUSA will conduct an OTA service campaign. Remote software updates are automatically downloaded and installed in the customer’s vehicle free of charge and do not require a dealer visit.

Complaint Vehicle will not start after DC charging Warning in the instrument cluster related to High‑voltage on board electrical system The following fault codes related to stuck contactor can be found in the High Voltage Control units : PTCU ‑ N127 (Powertrain control unit) • P154900 ‑ There is a warning due to overcurrent in the charging system of the high‑voltage electric circuit. • P154A00 ‑ There is a warning due to a detected crash event at standstill. • P154B00 ‑ There is a warning due to a stuck contactor. DCB223 ‑ N116/5 (Direct current charge connection unit) • P0E8929 ‑ The input current of the on‑board DC charging connection unit is too high. There is an invalid signal. • P2BC500 ‑ The contact ''Positive terminal'' of the contactor in the on‑board DC current charge‑connection unit is jammed closed • P2BCC00 ‑ The contact ''Negative terminal'' of the contactor in the onboard DC current charge‑connection unit is jammed closed. Instrument cluster warning messages : Cause • Cur

Complaint Slight creaking noises when steering. Cause Noises may come from one or more sleeves of the horn contact plate. Remedy Remove the horn contact plate and check the sleeves for noise; see attached video. If necessary, apply lubricant to the sleeves.

Complaint Customer complaints relating to automatic transmission 725.0 (NAG3 Classic /9G‑TRONIC automatic transmission) and 725.1 (NAG3 facelift/9G‑TRONIC automatic transmission facelift) For faster, more effective and more targeted diagnosis, Intelligent Predictive Repair (IPR) has been developed and integrated into XENTRY Diagnosis. This ensures an automated diagnosis process. Cause As part of the on‑going quality monitoring process and associated quality and damaged part appraisals, a high number of ineffective repairs have been discovered. Such ineffective repairs have a negative impact on all those involved. For the customer, it means high costs and long repair times and for the dealer, it may result in the warranty claim being rejected. Remedy General note: IPR is available for: ‑ NAG3 Classic (automatic transmission 725.0) ‑ NAG3 Classic ‑ AMG sport model (AMG 43 and AMG 53 with converter, automatic transmission 725.0) ‑ NAG3 Classic ‑ Hybrid (automatic transmission 725.0) ‑ NAG

Complaint Sporadic warning message in instrument cluster "Engine oil pressure, stop switch off vehicle" (or similar) is shown in red on vehicles with low mileage. Cause Directional control valve may stick. Remedy 1‑ Read off oil level in instrument cluster and correct if necessary. 2‑ Perform approx. 10‑15 engine starts, then clear fault codes. 3‑ Perform road test with vehicle. If fault code reoccurs during road test: Install new directional control valve.