Mercedes-Benz CLA 250 prices

Complaint The vehicle pulls to the left or right. Cause In vehicles with Car Package Release "CPR" 2.1.0 or prior, the calibration value for the straight‑line stability of the electric power steering is not fully calibrated. Remedy Install Car Package Release 2.1.1 or later. Straight‑line normalization is then relearned during normal driving followed by a bus sleep. After the update, fault code P063544 may be active and stored in the electric power steering control unit, as the learned end stops are deleted during the update. This does not result in any functional limitations or warning messages; the end stops are learned during normal vehicle use. The fault code is cleared by automatic means after the teach‑in of the end stops is complete.

Complaint Slight creaking noises when steering. Cause Noises may come from one or more sleeves of the horn contact plate. Remedy Remove the horn contact plate and check the sleeves for noise; see attached video. If necessary, apply lubricant to the sleeves.

Complaint 174 with MB.OS 2.1.3 ‑ Driver Assistance System Limited in Instrument Cluster and Does Not Self‑Extinguish. When vehicle is shut off, instrument cluster message appears for "Driver Assistance Systems Available". Cause Under Determination. Remedy Perform initial startup of the head unit (A26/17) and the intelligent drive controller (N62/5).

Complaint Noises in the steering column area when steering. See example file in the attachments area: "MRSM‑Schleifgeräusch_SCCMGrindingNoises. MOV". Cause Under analysis. Remedy Check which area of the steering column the noises occur in. Do the noises tend to occur at the bottom in the driver footwell or do they tend to occur in the area of the steering column switch module (MRSM/SCCM)? If the noises occur in the area of the MRSM/SCCM, work through the following points: ‑ Loosen screws of the MRSM/SCCM and steering wheel, re‑align the MRSM/SCCM, and re‑fasten the screws (see WIS). Sometimes there is stress at the MRSM/SCCM and noises occur. ‑ If noises continue to occur, swap the MRSM/SCCM into a vehicle without any (noise) complaints. ‑ If the noises occur with the MRSM/SCCM complained about when it is in the vehicle without a complaint (donor vehicle), the MRSM/SCCM can be replaced. ‑ If noises also occur in the customer vehicle with the MRSM/SCCM from the reference vehicle, the MR

Complaint Repeat workshop visit for vehicle vibration while braking from 60MPH. NOTE: Although the symptom is similar to a tire or wheel vibration, it is usually readily noticeable that it is distinctly different if it happens at all times or only while braking. Cause Although the cause of the vibration is most likely due to excessive lateral runout on the rotor or hub/wheel bearing, the system as a whole needs to be checked for other possible contributors. 1. Prior collision damage. 2. Excessive vehicle sitting times without rotating components. 3. Wheel bearing/hub lateral runout. 4. Wheel mating interface has been overtightened (did not follow WIS torque procedures). 5. Mating interfaces have been excessively modified (painted, gouged, bent, etc...). Remedy Read through the entire attached worksheet prior to performing. After performing, please review the final page and perform work accordingly. NOTE: This document is not pre‑authorization or otherwise dealing with warranty. This is